Green water treatment in 48 hours: the step-by-step guide

The complete procedure for clearing a green pool in 48 hours: step-by-step guide, products, and the two post-treatment steps everyone forgets.


Traitement d'eau verte en 48 heures : la marche à suivre

The short answer. Adjust the pH, remove debris, brush, apply the treatment in the evening, and filter continuously. Forty-eight hours later, vacuum to waste and clean the filter. This last step is the one almost everyone skips, and it is the one that decides whether the water stays clear.

This page is the step-by-step guide. If you are looking to understand why your water is turning green and how to prevent it from coming back, read green pool water: causes, solutions, and prevention instead.

Before you begin

A green water treatment only works if the basic chemistry is corrected first. Shocking water with a high pH is a waste of product: the added chlorine will barely work.

Bring us a water sample. The analysis is free and saves you from buying products you don't need.

The procedure, in order

1. Adjust the pH

Lower the pH toward the bottom of the recommended range before doing anything else. This is what makes the treatment effective.

2. Remove debris

Leaves, insects, deposits accumulated at the bottom. Everything removed now is chlorine saved.

3. Brush the walls and floor

Vigorously. Algae clinging to surfaces are protected from chlorine until they are dislodged. This is the most physical and rewarding step.

Focus on areas with poor circulation: corners, steps, behind the ladder, under the skimmer.

4. Apply the treatment

In the evening or at night, to prevent UV rays from destroying the product before it has had a chance to work.

The combination that works, with the pump running:

Follow the dosages indicated on the packaging. Doubling the dose does not double the result, and some products do not mix well together: add them separately, letting the water circulate between each one.

5. Filter continuously

Twenty-four hours a day until the water becomes clear again. This is the step that people cut short, and it is what makes the difference between 48 hours and a week.

On a variable-speed pump, turn up the speed: the economy speed does not circulate enough for a treatment.

After 48 hours: the two steps we forget

This is where most treatments fail, and yet it only takes half an hour.

Vacuum to waste, not to the skimmer

Dead algae fall to the bottom as a grayish deposit. Vacuum in waste mode if your setup allows it, to discharge these residues directly instead of sending them back into the filter.

If you vacuum normally, you are reloading the filter with everything you just killed.

Clean the filter

It has just captured a significant amount of dead matter. Backwash on a sand filter, or perform a thorough cleaning of the cartridges otherwise.

Without this, the flow rate drops, circulation weakens, and the water becomes cloudy again in the following days. Many people think the treatment didn't work when it was simply neutralized by a saturated filter.

If it doesn't work

After three days of continuous filtration, if nothing has changed, something fundamental has not been corrected.

The suspects, in order: a stabilizer level that is too low, allowing the sun to destroy the chlorine; a pH that rose during the treatment; or insufficient filtration flow.

Have the water fully re-analyzed before adding anything else. Adding product to already treated water without knowing the parameters is how you end up with a stabilizer level that is too high and a problem more difficult to fix than the original one.

The extra touch in-store

Bring in a sample of your water. Our team provides free analysis of pH, alkalinity, calcium hardness, stabilizer, and chlorine, and you leave with the exact amount of product you need.

It is almost always cheaper than buying by guesswork.

Frequently asked questions

Does it really work in 48 hours?
For water that is frankly green, yes, in most cases, provided you filter continuously and adjusted the pH before treating. Water that is nearly opaque may take several days and a second treatment.

Can I swim during the treatment?
No. Wait until the chlorine level has returned to normal and the water is clear.

Can I use my robotic cleaner during the treatment?
Wait until the chlorine levels have dropped. A high level attacks the seals and plastic parts of the robot.

The water is clear but there is still a gray deposit at the bottom.
These are dead algae. Vacuum to waste, in drain mode if possible.

My water turned green again a week later.
The treatment worked, but the underlying cause is still there. See the four underlying causes.


To learn more

Don't have time to take care of it? Our technicians perform treatments in the Laurentians and on the North Shore. Contact us or call 450-818-8200.



Discover certain products

1 of 4